|
|
| Turn
Table for spray finshing |
| Adjustable height rotating table
helps when spray finishing projects.
Top and bottom disks are 42-48" diameter
3/4" thick mdf.
Column is made from 1" and 1
& 1/4" threaded pipe. Pipe comes in ready made lengths from
home supply center.
|
 |
 |
Before cutting disks find the
center point of the 48" x 48" square by drawing lines from corner
to corner. Place threaded flange on layout lines and line up holes. Use a
center punch or marker to mark hole locations. |
| Drill 1/8" deep recessed holes
with a 3/4" diameter forstner bit at the indicated points.
Drill 5/16" through holes and insert
1/4-20 T-nuts. The T-nuts provide a
more secure mounting for the threaded flanges.
Repeat for the second disk. |
 |
 |
Turn disks over and screw threaded
flanges in place with 1/4-20 screws. |
| The disk with the 1"
diameter threaded flange becomes the top. Screw the 10" length
of 1" diameter pipe into the top threaded flange.
Screw a 10" section of the 1 1/4"
pipe into the bottom threaded flange. Screw on couplings and pipes as
shown on the right.
|
 |
|
Insert the 1" pipe into the
1 1/4" diameter pipe as shown on the left.
Your turn table is ready to use.
|
|
You adjust the table height by removing
sections of the 1 1/4" diameter pipe.
To store the turn table, unscrew the
pipes and roll the top and bottom away.
|
 |
|
|
